For fastening bushings and bearings exposed to high temperature loads.
- Maximum gap filling capacity of 0.2 mm
- Prevents fretting corrosion
- Strength at 100°C still 85 er maximum strength
- Fast curing
- Resistant to a wide range of alkalis, gases, solvents, oils and fuels
- Silicone and solvent free
Note
The following plastics may be attacked by prolonged exposure: ABS, celluloid, polystyrene,
Polycarbonate (Makrolon), PMMA (Plexiglas), Polysulfone, SAN (Luran, Tyril), Vinidur, vulcanized fiber and painted surfaces. We recommend that you always carry out your own tests.
The processing data are recommendations based on our tests and experience; before each application, carry out your own tests. Due to the variety of applications as well as storage and processing conditions, we do not guarantee any particular processing result. Insofar as our free customer service provides technical information or acts in an advisory capacity, this is done to the exclusion of any liability, unless the advice or information is part of our owed, contractually agreed scope of services or the advisor acted intentionally. We guarantee the constant quality of our products; we reserve the right to make technical changes and further developments.