For high-strength fastening of cylindrical connecting parts that are exposed to high loads.
Reliable curing at low temperatures around 0 °C.
Also a reliable helper in winter.
Gap filling capacity of 0.15 mm
Even very large deviations can be corrected at low cost.
Prevents fretting corrosion
Seizing of the bearings is prevented
Resistant to a wide range of alkalis, gases, solvents, oils and fuels.
DOS system:
-Practical one-hand operation due to the practical twist lock.
You always have one hand free for gripping.
-Variably adjustable dosing system Enables application-adapted, consumption- and cost-minimizing dosing.
-No residual material in the dosing neck
Cost optimization due to almost complete emptying
Note
The following plastics can be attacked by prolonged exposure: ABS, celluloid, polystyrene, polycarbonate (Makrolon), PMMA (Plexiglas), polysulfone, SAN (Luran, Tyril), Vinidur, vulcanized fiber and painted surfaces. We recommend that you always carry out your own tests.
NSF registered, class P1, reg. no. 151997
The processing data are recommendations based on our tests and experience; before each application, carry out your own tests. Due to the variety of applications as well as storage and processing conditions, we do not guarantee a specific processing result. Insofar as our free customer service provides technical information or acts in an advisory capacity, this is done to the exclusion of any liability, unless the advice or information is part of our owed, contractually agreed scope of services or the advisor acted intentionally. We guarantee constant quality of our products, we reserve the right to make technical changes and further developments.