Welcome to the future of cycling. Welcome to the world of e-bikes, where the future is now. As most of you already know - and most of the time - an e-bike is significantly more expensive than your conventional (non-electric) bike. The "electric" part of the equation makes e-bikes more expensive, which is why most suppliers usually skimp on accessories like lights. These standard lights are usually not strong when it comes to lumens (light output), which could very well jeopardize your safety day or night. For this reason, we recommend replacing this standard light with the name you've trusted for decades - NiteRider®.
Our e-bike lights come with a pre-wired power lead to connect to the e-bike's battery, making replacement seamless (NiteRider® recommends installation by an authorized e-bike service and repair shop). Whether you already have an e-bike or plan to buy one in the near future, make sure you take NiteRider® along for the ride - you'll feel safer and more confident having done so.
EPRO™ 1000 FEATURES
Epro™ 1000 is NiteRider's first headlight designed specifically for electric bikes. It comes with pre-wired power cable to connect to the eBike's battery. The power cable is approximately 52 inches long. The headlight is switched on with the ignition switch. Has two modes - continuous light and pulse flash - with integrated mode memory (saves the last setting).
- Lumen output: 1000
- 2 modes
- Hardwired, voltage 12 to 40 volts, 1.2 amps at 12 V, 300 mA at 40 volts
- Water/dust resistant to IP64
- Weight: 166 grams
- Suitable for seat posts from 22 mm to 31.8 mm
- Includes a pre-wired Epro™ 1000 headlight, handlebar clamp bracket and rubber mounting washers
LIGHT MODES
1) Continuous light ON
2) Pulse flash
Emax+™ 150 FEATURES
Emax+™ 150 is the first rear light from NiteRider designed specifically for electric bikes. It comes with a power cable that is pre-wired for connection to the eBike's battery. The power cable is approximately 52 inches long. The rear light turns on with the ignition/mains switch. Features six modes - steady light and alternating flashing - with integrated mode memory (saves the last setting).
- Lumen output: 150
- 6 modes
- Hardwired, voltage 6 to 80 volts DC
- Water/dust resistant to IP64
- Weight: 75 grams
- Suitable for seat posts from 22 mm to 34.9 mm
- Includes a pre-wired Emax+ 150 rear light, a seat post clamp bracket, rubber mounting washers and a luggage rack bracket
LIGHT MODES
1) Fast flash
2) Slow flash
3) Disco flash
4) Pulse flash
5) High continuous
6) Low steady light
NiteRider® recommends having this headlight installed by an authorized e-bike service and repair shop.Refer to your bike manufacturer's manual for compatibility information.Epro™ 1000 headlight not compatible with 6-volt systems.
FRONTLIGHT
| Lighting type | SET |
| Area of application | E-bike |
| Power supply | via eBike battery |
| Color group | black |
| manufacturer | NITERIDER |
| Luminous flux | 1000 lm |
| Bike lighting accessory type | E-bike light |